Modern industry continuously toward the direction of automation, electronic, high science and technology enterprises and the key laboratory of high to the requirement of the ground environment, not only requires the ground have anti-static function, and require high wear resistance and high impact on the ground, epoxy self-leveling anti-static floor coating system can meet the requirement, realized the high wear resistance, high impact and anti-static function of three-way one.

This system in the continuation of the traditional self-leveling floor coating system has the excellent performance at the same time, the added made from conductive powder and surface active agent of a two-component epoxy self-leveling floor coating system, can very effectively prevent electrostatic accumulation, and can bring foreign body gathered static release through conduction dissipation, has the function of prevent static sparks.

1. The coating is self-leveling and the surface is smooth and bright;
2. No seam, no dust, surface easy to clean;
3. Solvent free, environmental protection;
4. The electrostatic charge can be quickly leaked to prevent the damage and fire of electronic components due to static accumulation;
5. The surface resistance is stable and durable, not affected by weather humidity and surface abrasion;
6. Dense surface can resist the erosion of many chemicals;
7. A variety of colors are available for selection. Light color variety, black fiber may show more obvious

Applicable to the environment of stadiums and ground, school playground ground, garage ground, office ground, medical unit floor, residential district road ground, industrial plant ground wear high, high compressive requirements of the environment.

1. Check the ground and repair the cracks: check the ground after polishing and see if the ground is loose during the pulling process. If there is any need to repair with epoxy mortar.

2. Ground grinding and vacuuming: a professional floor sander is used to make the base surface to be polished once and for all (finally, the epoxy floor and the floor are tightly bonded together).
3. Dust off the ground.
4, determination of moisture in: "the test of rubber pads with 1 m * 1 m polyethylene film with tape (built-in dry towel) on the surface of the concrete after 24 hours, thus determine the number of condensed water.
5, epoxy anti-static primer: objective is a closed surface, primer infiltration ground, epoxy closely integrated with the ground floor (primer will be the main materials in proportion, curing agent, mixing, stirring evenly coating base, uniform requirements, no traces of leakage).
Dust the ground.
7. Laying of copper foil: bullet line (spacing 1m x 1m) pasting copper foil.
8. Epoxy antistatic coating: the purpose is to further repair, leveling the ground, preparing for surface painting construction. The main material of the slurry is mixed, the curing agent is mixed in proportion, the mixture is well mixed, the construction limit of the mixture is about 30 minutes, and the surface is smoothed with the trow-toothed trowel.
9. Light grinding and vacuuming on the base surface: a professional floor grinder will be used to make the base surface to be sanded once and for all (finally, the epoxy floors are better and more tightly bonded together).
10. Epoxy putty layer: the purpose is to further repair, leveling the ground, preparing for the painting construction. Apply the main material, the curing agent is mixed in proportion, stirring evenly, the construction limit of the mixing is about 30 minutes, brush over, make the surface smooth.
11, epoxy anti static level coating surface coating (or their flat paint) : the coating after curing, closed the construction area, don't allow other people in and out, clean up the ground again, carefully check, particles on the surface to remove, repair the defects on the ground, with a vacuum cleaner dust, clean the ground surface coating construction. To advocate material mix epoxy paint first, then add hardener to advocate material barrels, fully stir well, after spraying with high-pressure airless spraying machine, pay attention to the construction direction and interval, stirring barrels if found to have solidified block bottom coating, must stop use and replace the mixing barrel, after adding curing agent, the surface coating must be used within 30 minutes.